OPERATION & MAINTENANCE MANUAL SWE18UF
88
5.7 LONG-TERM STORAGE OF MACHINE
While storing the machine, retract the cylinder piston rod to the inside of cylinder as much as
possible to avoid piston rod corrosion caused by rain and wind, clean machine surface and all the
exposed parts.
Before storage
(1)
Grease the parts that need lubrication until fresh grease runs out.
(2)
Change engine oil.
(3)
Grease the exposed surface of piston rod.
(4)
Fill in diesel oil to the fuel oil tank to the full.
(5)
Choose a proper storage place
：
It’s best to store the machine in a room, if it can only be
stored outdoors, you should choose a flat ground and cover the machine with cloth.
During storage
(1)
Run the machine once a month during storage period.
(2)
Run the air-conditioner system once a month.
After storage
(1)
Wipe the grease off on piston rod surface.
(2)
Grease all the places that need lubrication.
(3)
Check engine oil level to make sure it is in a specified position, otherwise you should
fill oil. If there is any water in oil, change oil
(4)
Turn the key to “ON” position, switch accelerator button from low to high speed and
last for 3 seconds, then switch to low speed and start engine.
