Synway Information Engineering Co., Ltd
SMG Series Analog Gateway User Manual (Version 1.5.3)
Page 80
3.9.1 Management
Figure 3-91 Management Parameters Setting Interface
See Figure 3-91 for the Management Parameters Setting interface. The table below explains the
items shown in the above figure.
Item
Description
WEB Port
The port which is used to access the gateway via WEB. The default value is 80.
Access Setting
Sets the IP addresses which can access the gateway via WEB. By default, all IPs
are allowed. You can set an IP whitelist to allow all IPs within it to access the
gateway freely. Also can set an IP blacklist to forbid all IPs within it to access the
gateway.
SYSLOG
Sets whether to enable SYSLOG. It is required to fill in
SYSLOG Server Address
and
SYSLOG Level
in case SYSLOG is enabled. By default,
SYSLOG
is disabled.
Server Address
Sets the SYSLOG server address for log reception.
SYSLOG Level
Sets the SYSLOG level. There are three options:
ERROR
,
WARNING
and
INFO
.
The default value is
INFO
.
Send CDR
Sets whether to enable the feature of sending CDR. It is required to fill in
Server
Address
and
Server Port
in case Send CDR is enabled. By default,
Send CDR
is
disabled.
