1) If using the factory default stand mount
Stick on the dash board: Choose and
clean a right place on the dash board,
tear the paper of the monitor stand sticky
tape, put and press tight the stand mount
on the dash board.
2) If using the suction cup mount:
Use suction cup mount to replace the default stand via screwdriver.
2. How to mount the brackets:
Choose a right place on the windshield, and mount the suction cup mount
on the windshield. With the suction lever
in the released position, press the suction
cup against the windshield. Press the
suction ever toward the suction cup to
lock the mount. To adjust the angle of
monitor, loosen the collar on the ball joint,
tighten in the desired position again.
LICENSE PLATE HOLDER INSTALLATION
Align the license plate with the hole.
1
Align holes
1. Monitor pedestal could be attached to stand, vent, or
windshield as your requirements.
There are 3 kinds of mounting brackets accordingly.
- 5 -
- 6 -
Install the license plate holder on the car using screws, then tighten the screws.
2
or
or
ONTARIO
BFEJ 681
