81
11.4.1
Checklist for daily test of stationary applications by responsible operating
personnel
If the answer to any of the questions above is No, the machine should be checked by a
trained specialist.
1) Are there any problems in the external state of the protective
equipment, the cable, cable connections and any command
devices?
Yes
No
2) Are the fastening screws in the mounting system firmly
tightened?
Yes
No
3) Are the fastening screws in the
SD3-A1
firmly tightened?
Yes
No
4) Are both protective caps (X1 and X2) screwed on and are the
firmly in place?
Yes
No
5) Do the safety equipment and command devices show any
safety-relevant changes or gaps in safety (e.g. changes in
access possibilities or changes in the surrounding area)?
Yes
No
6) If the protective function of the
SD3-A1
is present for all
required monitoring cases (e.g. testing the switch-off function
with a test piece along the detection zone contour), the LED 3
for
SD3-A1
must light up with each attempt and the movement
that poses a danger must be stopped immediately. Possibility of
danger to the person running the test must be excluded?
Yes
No
7) Is the startup test / restart interlock (if there is one) working?
Yes
No
8) Does the base marking match the detection zone contour?
Yes
No
9) Do the necessary detection zones match the configuration
protocol?
Yes
No
10) If correct functionality is not certain or id the
SD3-A1
LED 5 is
flashing, take the machine out of operation immediately. Are any
doubts resolved?
Yes
No
Summary of Contents for SD3-A1
