SAFETY SYMBOLS, WORDS AND LABELS
What You Need to Know About Safety Instructions
Warning and Important Safety Instructions appearing in this manual
are not meant to cover all possible conditions and situations that may
occur. Common sense, caution and care must be exercised when
operating or cleaning your SupaScoota.
Always contact your dealer, distributor, service agent or manufacturer
about problems or conditions you do not understand.
WARNING indicates a potentially hazardous
situation which, if not avoided, could result in
death or serious injury.
CAUTION indicates a potentially hazardous
situation which, if not avoided, may result in
minor or moderate injury.
Radio wave sources may affect motorized vehicle.
- 3 - -
SAFETY INSTRUCTIONS
●
Please read this manual before using your SupaScoota.
●
Check the frame lock and all clamps before using your SupaScoota.
●
Do not turn your Scooter “On” before you are seated ready to go.
●
Practice riding in an open area free of vehicles, pedestrians and
obstacles before using your SupaScoota near other people. It is also
recommended that you have someone accompany you during
practice.
●
The SupaScoota was designed for hard and flat surfaces. It should
not be used on steep slopes or loose surfaces
●
Reduce speed when turning.
●
Driving in wet conditions is not recommended.
●
For your safety, it is recommended that you wear a helmet.
●
Do not operate the Forward/Reverse switch when moving. This could
damage your SupaScoota.
●
Do not use the SupaScoota on slopes over 8 degrees.
●
When the yellow battery light comes on, you should recharge your
battery as soon as possible. If the red battery light comes on or is
flashing, you should stop immediately and recharge.
●
Always switch the power “Off” before leaving your scooter or while it
is unattended. You can also disconnect the battery plug before
leaving your scooter.
●
Do not put your fingers on the Speed Lever before you turn the key
switch “On”. This could cause the SupaScoota to move without
warning.
●
Your key switch must be in the “Off” position before connecting the
battery lead.
- 4 -
