4400 Earth City Expy, St. Louis MO 63045
866-590-3533 support@superbrightleds.com
Care and Maintenance:
To clean, unplug lamp and wipe with a damp, non-abrasive cloth.
Troubleshooting
Warranty
Warning
PROBLEM
LED light will not turn on
LED light flickers
POSSIBLE CAUSE
1. No power.
2. Loose wire to the connector
3. Connector not making contact with
primary cable.
4. Power pack/transformer’s photo
cell sensor is exposed to unwanted
light source.
1. Wattage of power pack/transformer
may be exceeded.
CORRECTION ACTION
1. Wattage of power pack/transformer may be
exceeded.
2. Make sure brass contact pins pierce the plastic
wire insulation and are touching the copper
wires inside.
3. Make sure cover is tight. If problem persists,
repeat steps 3 to 6 on the instructions.
4. Make sure that power pack/transformer’s photo
cell sensor is not exposed to lights.
1. Check manufacturer’s specification for
maximum wattage.
The manufacturer warrants all of its products against defects in materials and workmanship for three (3) years from the date of purchase.
If within this period the product is found to be defective in material or workmanship, please contact the manufacturer, a copy of the
original sales receipt will be required as proof of purchase. The manufacturer will, at its option, repair or replace the product. This
warranty does not cover products becoming defective due to misuse, accidental damage, improper handling and/or installation and
specifically excludes liability for direct, incidental or consequential damages. As some states do not allow exclusions or limitations on an
implied warranty, the above exclusions and limitations may not apply to you. This warranty gives you specific legal rights, and you may
have other rights that vary from state to state.
•
Risk of fire or electrical shock. Read all of these
instructions thoroughly before use. Keep this instruction
manual in a safe place for future reference.
• Do not install or connect wires with wet bands.
•
Do not install this product within 10 ft. from a pool, spa,
fountain, or other body of water.
•
The fixture wire and primary cables are intended for
shallow burial - maximum depth must not exceed 3 in.
•
For low-voltage landscape lighting systems only.
• Do not step on or drive over the branch cable or power
cable.
Caution
•
This lighting fixture is only suitable for a 12~15volt
power supply.
•
This LED lamp is a highly efficient, extremely low
wattage, energy-saving product. However, it is not
recommended to use a power pack/transformer over
100 watts.
•
Use shielded cable for outdoor use in the following
sizes: 18G, 16G, 14G, 12G.
• Do not submerge in water.
•
Do not repair or modify this product.
