31
H.264 Video Surveillance System Setup Guide
SECTION 4: DVR SETUP
To enable blocks (areas) for motion sensing, click the block, or use the mouse to drag a rectangle over areas you want to
enable. The shading will disappear for areas selected for motion detection. To disable an area selected, click on it.
Motion Sensing
Disabled
Motion Sensing
Enabled
6. After the motion sensing areas are selected (unshaded), right click to return to the MOTION DETECTION SETUP menu.
7. Check the box to right of the
RECORD
label to enable recording when motion is detected.
8. Check the box to right of the
BUZZER
label to sound the buzzer when motion is detected.
9. Check the box to right of the
PRERECORD
label to add the previous 5 seconds of video from the camera to the motion
detection recording.
10. Check the box to right of the
label to send an email when motion is sensed. To use this feature, the EMAIL configuration
settings in the NETWORK tab must be configured.
11. After configuring your motion detection settings, click the confirm icon (
a
) in the lower right corner of the screen, then click
the
Confirm
button in the
Note
window.
12. Repeat the steps above for the other camera channels.
