19
20
Hammer M3 Tee nut into F27. Drop some
instant glue around the nut.
Place 4 pieces of F40 on the working table.
Use UHU glue to secure 2 pieces of F40
together.
Place F6, F8, F9, F16 on the working
table. Please note there is a small recess
on the right top of the F16.
Try to fit the F6, F8 and F9 into the F16.
Make sure the angle between F8/F9 and
F16 is 90 degree. The cross marking on
the F6 must face outside. The angle
between F6 and F16 is 92 degree.
Please note the small recess marking on
the F16 and F6 must on the same side.
Drop instant glue to secure F6, F8 and F9
in place.
Close view of the small recess marking on
the F6 and F16.
Try to fit the F5 on the F16, before the F6.
Make sure the angle between F16 and F5
is 90 degree.
Use instant glue to secure the F5 in place.
Place F1R, F1L, F2R, F2L, F15, F3
(2pieces) and F4 (2 pieces) on the working
table in order for assembling the side
boards for fuselage. Use instant glue to
secure the F3 on the top of the side board;
secure F4 on the bottom of the side board
and secure the F15 on the tail.
Use UHU glue to secure the F1R on the
F2R and secure F1L on the F2L.
Place F17A o the side board; don't over
the marking line on the picture.
F1R
F1L
F2R
F3
F17A
F15
F4
F2L
F3
F4
F17A
F1R
F1L
F2R
F3
F17A
F15
F4
F2L
F3
F17A
F4
