27
28
Close view of the round edges (R3).
Use hobby knife to cut the hinge hole on
the center of the tail.
Completion of the fuselage. Please note
when hold the fuselage, it is better to hold
the sides avoiding the trips on the tail.
After applying the covering on the top and
sides of the fuselage; insert the rod tubing
(for elevator rod) through the fuselage and
exit from the preserving holes on the tail.
The elevator rod tubing will go through the
center hole on the F9.
Use hobby knife to cut hole on the right
side of tail for exit the rudder rod tubing.
The rudder rod tubing will go through the
right hole on the F9.Iron on the covering
over the bottom of the fuselage.
CANOPY ASSEMBLY
Place F29, F30, F31, F32, F33, F34, F35
and F36 on the working table as the
picture shown.
Try to fit the F30 on F29. Use the F33 as
the triangle ruler and drop instant glue to
secure the F30 on F29. Remove F33.
Use F33 as the triangle ruler and try to fit
the F31 on the center part of F29. Use
instant glue to secure the F31 in place.
Remove F33.
Use F33 as the triangle ruler and try to fir
the F32 on the tail of F29. Use instant glue
to secure the F32 in place. Remove F33.
Completion of the main construction of the
canopy. F33 is the ruler, cannot be fixed
into the kit.
