29
30
Spray the red color onto the white canopy.
Wait for it dried enough.
Apply the masking tape around the edge
of the pilot seat.
Place paper over other part on the canopy
except the pilot seat. Use the masking
tape to secure the paper in place for
temporary. Spray the pilot seat into black.
Wait for the spray dried enough.
Remove the masking tape and the paper.
Place the canopy and main construction
(with F32 on the right side) on the working
table.
Spread UHU on the main construction.
Place the main construction onto the
canopy.
Make sure the alignment of the edges and
place some heavy thing on top of it. Wait
for the glue dried enough.
Try to find 3 pieces of preserving markings
on the canopy. Use 2.6mm driller to drill
holes on the markings.
There are 2 pieces of recess next to the
pilot seat. Use 2mm driller to drill holes on
the right and left sides inside the recess.
Try to find 2 pieces of preserving markings
inside the pilot seat. Use 2.6mm driller to
drill holes on the markings.
Use instant glue to secure the F34 on the
F30 as the latch-lock.
Use instant glue to secure the F35 on the
center position of the canopy.
