37
Press the edges of the decal toward the
hinge and makes it flat.
Place the ruler on the conjunction of the
main wing and aileron. Use hobby knife to
cut the decal and makes the aileron
separate from the main wing.
Remove the aileron and insert the hinges
into the slots.
Insert the hinges as the picture shown.
Spread UHU glue on the surface of hinges
and drop instant glue around the edges of
hinges for securing the hinges in place.
Install the aileron onto the main wing.
Keep the gap between main wing and
aileron around 0.5mm and drop some
instant glue to secure the hinge into the
main wing.
Place the horizontal on the working table.
Remove the elevator from it.
38
Drop some instant glue to secure the
hinges into the elevator.
Install the elevator to the horizontal. Keep
the gap between horizontal and elevator
around 0.5mm and drop some instant glue
to secure the hinges into the horizontal.
Place the vertical on the working table.
Use hobby knife to separate the rudder
from vertical.
Drop some instant glue to secure the
hinges into the rudder.
There is pre-serving slot on the bottom of
the rudder. Try to find this slot and use
hobby knife to remove the covering over
this slot.
Try to find the tail gear from the hardware
bag and insert the gear into the slot. If
satisfy the installation, spread some
instant glue on the gear wire and secure it
inside the slot.
