39
Try to find the pre-serving holes on the
main wing for servo, for cable exit, for
screw and for horn as the picture shown.
Use soldering to melt out the covering
over these holes. Drop small instant glue
on screw holes for reinforcement.
Place the bottom wing and wing
reinforcement on the working table with
the back facing upward.
Use soldering to melt out the covering
over the screw holes.
Spread UHU glue on the wing
reinforcement and secure it onto the
bottom wing. Make sure the alignment of
the rear edges and the screw holes.
Use clip to hold the wing reinforcement in
place for temporary until the glue dried
enough.
40
Try to find the pre-serving 8 holes for both
sides of fuselage. Please refer to the
picture. (7 holes are for screw; 1 bigger
hole is for cable exit)
Use soldering to melt out the covering
over these holes. Drop some instant glue
on the screw holes for reinforcement.
Place the front cover of the fuselage on
the working table. Try to find the pre-
serving 10 holes on it as the pictures
shown.
Use soldering to melt out the covering
over these holes.
There are two holes on the tail of the
fuselage for securing the tail gear mount.
Use soldering to melt out the covering
over the holes.
