45
on the center slot.
Try to find 2 pre-serving slots on the
center part of the horizontal.
Use hobby knife to remove the covering
over the slots.
Try to fit the vertical into the slots. When
satisfy the location, use pen to mark the
outline of the vertical on the horizontal.
Remove the vertical. Use hobby knife to
remove the covering inside the marking
area carefully. Don't cut into the wood.
Fit the vertical on the horizontal again.
Use a triangle rule as a guide for making
sure the angle is 90 degree and secures
the vertical in place with instant glue.
Try to fit the tail wing into the fuselage.
The vertical must be fitted into the slot on
the tail of the fuselage. When satisfy the
location, use pen to mark the outline of
fuselage on the horizontal.
46
Remove the tail wing. Use hobby knife to
remove the covering inside the marking
area on the tail wing.
Place the control horn set on the working
table, including top and bottom plastic
mounts, M2 x 25mm screw, 2mm nut and
one plastic horn. Insert the screw through
the bottom plastic mount, elevator and top
plastic mount and secure the screw with
2mm nut. Screw the horn onto the top the
screw until even to the screw.
Place the control horn set on the working
table and install onto the rudder.
Place the fuselage, vertical and horizontal
on the working table. Please refer to the
drawing A and try to fit the vertical and
horizontal into the fuselage. Place the
main wing onto the fuselage for temporary
when measure the distance between the
main wing and tail wing. Make sure the
distance must match the drawing A. This
is very important before securing the tail
wing into the fuselage.
Remove the vertical. Mix generous AB
glue, spread on the balsa wood (the area
without covering) of the horizontal and
secure the horizontal onto the tail of the
fuselage. Use pins to hold the fuselage in
place for temporary until the glue dried
enough.
