49
Place the ESC, propeller, aluminum nut,
motor and its relative accessories on the
working table.
Place the cross metal mount on the fire
wall and set the cross mark on the center
position of the metal mount. Use maker to
mark the out-most 4 holes on the cross
mental mount.
Use 2.6mm driller to drill open the 4
marked holes on the fire wall. Drop dome
instant glue into the holes for
reinforcement.
Use hobby knife to cut off the center circle
hole on the fire wall.
Secure the motor on the cross metal
mount with provided screws. Connect the
motor with ESC, set the ESC through the
hole on the fire wall and secure the ESC
on the bottom of the fire wall with Velcro
tape. Secure the motor onto the fire wall
with 3x16mm tapping screws.
Place the FRP cowl and venting net on the
working table.
50
Try to fit the venting net onto the FRP
cowl. Fold the bending part if necessary.
Spread some UHU around the edges for
attaching the venting net. Wait for 2
minutes and attach the venting net onto
the cowl.
Try to press the venting net onto the cowl
until the glue dried enough. It takes
around 10 minutes.
Try to install the cowl to the nose, check if
it will interrupt the operation of the
propeller. When satisfy the location, use
2.8mm tapping to secure the cowl in
position. It needs to check and set the
If equipped with short motor; please use
the plates on F-42 to make the motor
longer.
operation of the ESC and motor before
securing the propeller. Therefore, please
don't secure the propeller right now.
Place 6 pieces of long carbon fiber tubes,
2 pieces of short carbon fiber tube and 14
pieces of M2 x 25 screws on the working
table.
Use nipple pliers to remove the heads of
screws.
