51
Use sanding paper to trim the ends of
screws. Use wing strut gauge (including in
the hardware bag) as a guide and insert
the screws into the CF tubes to their
respective length.
Please refer to the picture and set the
length of the screws.
Use instant glue to secure the screws
inside the CF tubes. Let dry.
Use the wing strut gauge as the guide and
insert the black plastic ball-end to both
ends of the CF tubes.
Now, there are 6 pieces of long rods and
2 pieces of short rods. Please use the
gauge to make the length is correct.
Insert the metal balls into the plastic ball-
ends. When press the metal ball, one end
keeps short metal, another keeps longer
metal.
52
The longer metal end will be connected
with strut. Please arrange the rods as the
picture indicated (two long, one short and
one long in order). Use M2x10mm screws
and plastic nuts to secure the rods in
location.
Repeat the same procedure and connect
the rods to the right side strut.
Place the left and right side struts on the
sides of fuselage. Secure the rods on the
fuselage with 2x15mm tapping screws.
Top view of installing struts to the
fuselage.
Secure the control horn set onto the
aileron of top wing.
Connect the servo with 30cm cable. Apply
a piece of transparent tape on the
connecting place for avoiding loosing off.
Connect the plug of extension with the
cotton string inside the servo tray, and
apply a piece of transparent tape to hold
the conjunction in place for temporary.
