3
4
place. Fit the rib W6 from the center part.
Fit other ribs W7, W8, W8, W7, W9, W10,
W12, W13, W14 in order.
Try to fit the 5mm dowel as the leading
edge. Use triangle ruler when drop instant
glue to secure the dowel on the W5.
Try to fit the W3 on the main wing as the
middle edge.
When satisfy the location; place some
heavy thing (1 KG) on the middle edge.
Place a long straight ruler on the leading
edge. Make sure the angle between the
ribs and leading edge is 90 degree. Use
instant glue to secure the joint places on
the leading edge.
Try to fit W5 on the main wing as the rear
edge.
. Make sure the alignment of ribs on the
W5. Drop instant glue to secure them in
place.
Try to fit the W16R as the front edge of
aileron on the main wing. Please note:
there is W16R (for the right wing) and
W16L (for the left wing). The flat surface
must face downward; the thick part must
face the wing tip.
Press the W16R and makes the ribs fit into
the slots. Drop some instant glue on the
joint places.
Place the W17, W18, W19 on the working
table.
Try to fit the W17 into the slots on the W15.
Drop some instant glue to secure the W17
in place. Try to fit the W18 between the
middle edge the W17. Please note the
angle must be 90 degree. When satisfy
the location; use some instant glue to
secure the W18 in place. Try to fit the W19
into the W17 and use instant glue to
secure it in place.
Use A piece of double-side adhesive tape
to secure the sand paper on planking; use
it to trim the uneven surface or excess
glue.
Please check if there is any joint places
need to be secured by instant glue. Apply
some UHU glue on the joint places of
leading edge (dowel) and ribs. Wipe off
the excess glue.
Place W20, W21 each 2 pieces on the
working table. Please note the direction.
There is one small hole on the W20 and
W21. Place the side of the small hole face
the center part of the main wing.
