5
6
Try to fit the W20 on the main wing (near
the leading edge); and fit the W21 on the
main wing near the rear edge. Press them
into the slots and drop some instant glue
to secure them in place. Apply some UHU
glue from inside for reinforcement.
Place W22 on working table.
Try to fit the W22 on the main wing as
servo tray. Press the W22 into the slots
and drop some instant glue to secure it in
place.
Place W23, W24, W25, W26, W27 as the
picture indicated on the working table.
Try to assemble W23, W24, W25, W26,
W27 and press them into its relative slots.
Make sure the angle must be 90 degree.
Drop some instant glue to secure them in
place. Use sand paper to trim the uneven
surface.
The assembly of top main wing is
completed and wait for apply film.
Place the MW3 and MW2 on the working
table and the slot part upward.Both parts
must be very straight.
Try to place the 3mm wide of MW3 on the
bottom of the MW2 (the side without any
gaps). Use triangle rulerwhen apply
instant glue.
Close view after gluing MW3 on MW2.
Place MW7 (2 pieces), MW8 (2 pieces)
and MW9 (2 pieces) on the working table
like the picture shown.
Apply UHU glue to secure MW8 on Mw9.
Please refer to the picture. Spread some
UHU on the surface of MW8 and place
MW7 on MW8. Use clip to hold them
together until the glue is dried enough.
Make sure the MW9 combinations remain
aligned. Drop some instant glue on the
edges.
These two MW9 combinations are for left
and for the right.
BOTTOM MAIN WING ASSEMBLY
