7
8
Top view of both MW9 combinations.
Place MW2, MW9 combinations and MW4
on the working table.
Try to fit the MW9 combinations onto the
MW2 and MW4 like the picture shown.
Left MW9 combination must be on the left
side. Don't use any glue.
Place MW10 (4 pieces) and MW11 (2
pieces) on the working table.
Use UHU glue to secure the MW10 on
both sides of MW11. Use clip to hold them
in place until the glue is dried enough.
Drop some instant glue on the edges.
Completion of left MW11 and right MW11
combinations.
Top view of the left and right MW11
combinations.
Refer to the assemble drawing when
assemble the ribs to the bottom main wing.
Try to fit the rib MW6 from the center part.
Fit other ribs MW9 (6 pieces), MW11,
MW12 in order.Don't apply any glue to the
ribs. Fit MW2 and MW4 to the main wing
and drop small amount of instant glue to
fix them in place temporary. Drop some
instant glue to secure the MW12 on the
main wing as the wing tip.
15. Try to fit MW3 to the main wing as the
middle edge and press every ribs into its
relatives slots. Don't apply any glue to the
ribs.
Try to fit the 5mm dowel MW1 as the
leading edge. Use triangle ruler when
drop instant glue to secure the dowel on
the MW12.
Make sure the alignment of every rib and
place some heavy thing (1 KG) on
themiddle edge. Place a long straight
ruler on the leading edge. Make sure the
angle between the ribs and leading edge
is 90 degree. Use instant glue to secure
the every joint place on ribs.
Try to fit MW5 on the main wing as
