9
10
the rear edge.
Make sure the alignment of ribs on the W5;
press the ribs into its relative slots on the
MW5. Drop instant glue to secure them in
place.
Place MW13 and MW14 on the working
table.
Fit the MW13 to the main wing as the wing
tip. Fit the MW14 into the slot on the
middle edge between the main wing and
MW13. The angle between the MW14 and
MW13 must be 90 degree. Drop some
instant glue to secure the MW14 in place.
Please check if there is any joint places
need to be secured by instant glue. Apply
some UHU glue on the joint places of
leading edge (dowel) and ribs. Wipe off
the excess glue.
Use sanding paper to trim the uneven
surface, wing tips and rear edge; wait for
apply films.
Place MW15 and MW16 on the working
table. MW16 will be applied film on one
side. MW15 won't need any film. Don't
glue MW15 and MW16 to the bottom wing
right now.
LANDING GEAR SUB WING ASSEMBLY
Place the DW7 (4 pieces) and Dw8
(2 pieces) on the working table as the
picture shown.
Use UHU glue to secure DW7 on both
sides of DW8. Make sure the alignment of
the edges and use clip to hold the
combination temporary until the glue is
dried enough. Drop some instant glue on
the edges.
Top view of the DW7 combinations. There
is one small hole on the top.
Place the following parts on the working
table in order:
DW1leading edge
DW7 (2 pieces)ribs
DW6 (2 pieces)ribs
DW5 (3 pieces)ribs
DW2..middle edge
DW3.secondary edge
DW4.rear edge
Try to fit ribs to the DW2 and DW3.Don't
use any glue now.
Try to fit 2 pieces of DW7 on both side of
sub wing. Please note the hole on DW7
must face the upward.
