11
12
Make sure the alignment of every ribs and
every angle must be 90 degree; use
instant glue to secure the joint places.
Spread some UHU glue on the joint places
of DW7 with DW2 and DW3.
Place DW4 on the working table.
Try to fit DW4 to the bottom of the sub
wing as the rear edge. Drop some
instant glue to secure it in place.
Place DW1 on the working table.
Try to fit the DW1 to the sub wing as the
leading edge. Make sure the alignment of
every ribs and drop instant glue to secure
ribs on the DW1.
Use sanding paper to trim the
leadingedge and uneven surface,
chamfer the rear edge.
Completion of the sub wing and wit for
apply films.
ELEVATOR ASSEMBLY
Place the H1 (horizontal), H4(2 pieces)
and H5(2 pieces) on the working table.
Try to fit H4 and H5 into its relative slot on
the H1. Make sure the surface is flat and
drop instant glue to secure them in place.
Use sanding paper (#150-200) to trim both
sides of horizontal. Don't trim too much;
make sure the thickness is 5mm.
Use sanding paper to trim the side edges
into round edges (R5).
Close view of the round edges. It makes
the horizontal looking better and avoiding
disturbed flow.
