Use a hobby knife to cut out the
pre-serving cooling holes on two sides
of the fuselage.
Use 2mm driller to drill a hole on the
rudder. Secure a control horn on this
hole.
Insert the rods into the out tubes.
Connect the clevis with the control
horns for both elevator and rudder.
Use 2mm driller to drill a hole on the
bottom of the elevator (near the
fuselage). Secure a control horn on
this hole.
Take 2 pieces of intake cowls from the
hardware bag and trim the edges.
It must have 2mm more on the edges
and an opening in the front.
Glue the intake cowls on cooling holes.
5
6
Secure the out tube for the rudder
pushrod on the top of fuselage using
CA glue. The length of the out tube is
25-30mm shorter than the rod.
Secure the out tube for the elevator
pushrod on the bottom of fuselage
using CA glue. The length of the out
tube is 25-30mm shorter than the rod.
Using a 90-degree triangle, make
sure the fin is perpendicular to the
horizontal. Use masking tape to
hold the vertical fin in place until
it's completely dry.
Use hobby knife to cut three pre-
serving slots on the bottom of the
fuselage.
Install the skid on the bottom of the
fuselage and secure it in place using
CA glue.
