Replacing V-Belt
1. Loose 4 engine mount bolts (do not remove) only enough to move the engine forward.
2. Loosen the jam nuts A shown in above figure.
3. Slide the engine toward the front of plate and slip the old V-belt off of the wheel pulley and
install the new V-belt in their place.
4. Position the V-belt over the engine pulley.
5. Move the engine back.
When adjusting the belt, make sure that the clutch pulley is in alignment with
exciter pulley.
6. When the V-belt tension is correct, tighten the jam nuts A and the engine mount bolts.
7. Replace the belt guard.
When removing or installing the drive belt, be careful
not to get your fingers caught between the belt and
pulley.
Exciter Lubrication
The exciter housing is pre-serviced using Automatic
Transmission Fluid Dextron l, Mercon, EXXON(ESSO)
NUTO H-32 or its equivalent. Change fluid after
200 hours of operation.
1. Let exciter cool before changing exciter oil.
2. Remove the belt guard (A
)
,V-bel
t (
B
)
,and baffle (C)
）
.
3. Remove the bolts that hold the deck to the housing.
4. Lift entire deck with engine from housing.
12
Summary of Contents for GUO039
Page 17: ...Parts Breakdown 16...
Page 19: ......
