1
Turning the brake handle forward, and close the screw with Hex key.
VERY IMPORTANT: Always make sure the components are fixed very well before drive.
FOLDING SCOOTER
Make sure power is off.
Release locking hasp under seat, and remove seat. Close foot pedal.
Push the button in folding clasp (1), and open the clasp (2), slowly turn front wheel backward.
Close it in back frame.
Release upper locking hasp in handlebar, go down lowest position, and close locking hasp. If
need to remove handlebar from frame, release lower locking hasp in middle bar, and take out
he handle bar.
The scooter can be kept in smallest size.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights.
1. Loosen the locking hasp.
2. Remove seat and its attached seat post by twisting seat left/right, and remove from seat
frame.
3. Remove clevis pin from the seat post.
4. Raise or lower the seat and its attached seat post to the desired seat height.
5. While holding the seat at the desired height, align the adjustment holes of the seat post with
notch of seat frame.
6. Fully insert clevis pin.
7. Tighten the locking hasp.
7
1
2
