Super Handy GUO056, Operator'S Manual

OPERATION

This leaf shredder is only used for shredding leaves, grass 

clippings, etc. It is not suitable for shredding branches or 

long fiber plants which above 0.5". Do not overwork! 

Stop the leaf mulcher every 20 minutes, restart until 

it is fully cool down. Duty Cycle: S2.

1. Before operating the Shredder, put on ANSI-approved 

safety goggles and other safety gear. Safety goggles 

and other safety gear are sold separately.

2. If an extension cord is used, ensure that it is an 

outdoor type extension cord and that it is the 

correct design to accept this appliance’s plug.

3. Check that the Power Switch is OFF.

4. Check that the feed inlet is empty.

5. Plug the Power Cord into a 120VAC/60Hz outlet.

6. Turn on the Power Switch.

7. Do not shred soft, damp leaves it may clog the 

Shredder. Let damp garden waste dry for a 

few days before shredding.

8. Use the push paddle to feed leaves and other 

small material into the Hopper.

9. Feed material into the Shredder at the rate that 

the machine pulls the material. Do not force 

material into the machine.

10. Wait for all material to pass through the Shredder before turning the unit off.

11. To prevent accidents, turn the power off, and disconnect the power supply after use. Clean, 

then store the appliance indoors out of children’s reach.

OVERLOAD PROTECTION

This Shredder is equipped with an overload protection system. If the unit clogs while running, 

the overload protection system will shut the power off. Wait at least one minute before 

restarting. Press the Reset Button then turn the Power Switch on.

MAINTENANCE AND SERVICING

Procedures not specifically explained in this manual must be performed only by a qualified 

technician.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC 

SHOCK:

Turn the Power Switch of the appliance to its “OFF” position and unplug the appliance from its 

electrical outlet before performing any inspection, maintenance, or cleaning procedures.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem 

corrected before further use.

1. BEFORE EACH USE, 

inspect the general condition of the tool. Check for:

• Loose hardware

• Misalignment or binding of moving parts

• Cracked or broken parts

• Damaged cord/electrical wiring

• Any other condition that may affect its safe operation

2. AFTE  USE, 

clean external surfaces of the appliance with clean, moist cloth.

E8

Reset Button
Power Switch

Power Cord