Super Handy GUO056, Operator'S Manual

3. Replace or sharpen the Blades as needed. 

4. If the motor turns but the appliance does not function, the belt may be broken. Have the belt 

replaced by a qualified technician.

TROUBLE SHOOTING

1. Normal and regular maintenance will extend the service life of the equipment.

2. The following troubleshooting guide lists the most common problems, causes and solutions.

E9

PROBLEM

Engine won't start.

Engine stops suddenly.

Cutting ability reduced.

Abnormal vibration of 

equipment.

Note: Stop the motor 

immediately and 

disconnect the 

power.

POSSIBLE CAUSE

1. The cutting blade is stuck.

2. The motor is overheated.

3. The extension cord is too long.

4. The device is not connected to power.

5. The overload protector starts.

6. The motor or electrical components is 

malfunction.

1. Turn off the power switch unexpectedly.

2. Disconnect the power plug.

3. The motor is overheated.

4. The overload protector starts due to 

the blockage.

5. The motor or electrical components is 

malfunction.

1. The blade edge is worn.

2. The blade is not installed correctly.

3. The discharge port is blocked.

4. The extension cord is too long.

5. There are other electrical loads 

connected to the power supply.

1. The blade is loose or unstable.

2. The equipment fastener is loose.

SOLUTIONS

1. Remove the blockage.

2. Operate the equipment in the area 

with air circulation.

3. Select extension wire reasonably. 

(high power loss due to resistance).

4. Connect the power supply.

5. Reset the overload protector.

6. Repair or replacement by 

professional technicians.

1. Restart the power switch.

2. Reconnect the power plug.

3. Run after cooling the motor. 

4. Reset the overload protector after 

removing the blockage.

5. Repair or replacement by 

professional technicians.

1. Replaced by professional technicians.

2. Installed by professional technicians.

3. Remove the blockage.

4. Select extension wire reasonably. 

(high power loss due to resistance).

5. The device should connect to the 

power supply separately. (Other 

electrical loads will reduce power)

1. Check blades and replace as 

necessary.

2. Tighten bolts and nuts.