5-10
Publication: 0028607
WATER RECYCLING SYSTEM
5
End of Day Procedure
1.
Run a compaction cycle to remove as much water as
possible from the debris collected. DO NOT exceed
1500 PSI on the passenger side compaction gauge
(1).
Figure 5-19
2.
Use up as much water from the debris tank as
possible.
3.
When the NOT ENOUGH Wastewater to Recycle
warning (2) is displayed on the front control panel
HMI screen, you can continue jetting using the
recycled water by depressing and holding the
recycling button. The system will continue to work
until most of the water available in the debris body
has been used.
Figure 5-20
4.
Open the front drain valve (3) to drain off the
remaining water in the debris body.
Figure 5-21
5.
Turn off the recycling system using the rocker switch
located on the front control panel. See Figure 5-6.
6.
Close the recycling butterfly valve on the driver’s
side. See Figure 5-4.
7.
Run fresh water through the system for 20–30
seconds by increasing the PSI dial on the front
control panel.
NOTE
The recycling system must be off to perform a fresh flush.
8.
Perform a fresh water flush by selecting FRESH
FLUSH (4) on the front control panel HMI screen.
Figure 5-22
1
ok
2
3
ok
4
Summary of Contents for Camel 1200 (Dump Body)
