Updated: 10 October, 2009
Page 15
REF: REI-90-0611
(2)
Sealing film stop at
wrong position
after sealing.
Film eye-mark sensor in wrong
position
Film stop is in wrong position.
Adjust the eye-mark sensor
position and clean the sensor.
Adjust the film roll and
clamp.
(3)
Poor sealing
performance
Film material is not suitable for the
container.
The heater is not clean.
Sealing time is too short.
Cutter is not sharp.
The groove between the cutter
and heater is not clean.
Change the film material.
Clean the heater.
Increase the sealing time.
Change a new cutter or re-
sharp the cutter.
Clean the groove.
