SUPER STEAM X5
54
HOW TO ASSEMBLE HAND-HELD STEAMER
HOW TO USE HAND-HELD STEAMER
7. Attach the Duster Frame to the Extension Hose as follows:
Align the lock button on the Extension Hose with the designated
hole on the Duster Frame and then
push in the Extension Hose until it locks in place (as illustrated in
Fig. 7b).
Make sure that the SUPER STEAM X5 is unplugged.
1) Fill the Water Tank with water. Please re-
fer to the “HOW TO USE THE SUPER STEAM X5”
section in this manual.
Attach either the round nylon brush or the
round copper brush as explained in the “How to
assemble Hand-Held Steamer” section in this man-
ual.
2) Select one of the following
Steam Regulator positions:
1 - Low, 2 - Medium, 3 - High or
4 - Hot Spray.
You can change the Steam Reg-
ulator position and the steam output while operat-
ing the SUPER STEAM X5.
3) When the unit has been fully assembled and
filled with water, plug in the power cord to ground-
ed electrical outlet. When the red indicator light started blinking,
that indicate the machine start preheating pump switch(0/l) is in the
off(0)position(higher position). Wait for 20 ~ 25 seconds, the com-
pletion of preheating, red Iight stops blinking, that machine can be
