2
1.Installation Precautions
1. Make Sure The Pipeline Are Fully Secure And Sealed.
2. Pipeline With Lots Of Bends Please Install A Water/Solution Inlet Pipe
3. If The Filter Must Be Installed Outdoors,It Is Essential To Provide Adequate
Covering.
4. Base On The Chemical And Solution Temperature Please Select The Most
Suitable Pipe Material.
(Ex: PP Is Use For Solution Exceeding 60
o
C)
5. Before Connecting Any Pipeline To The Pump,Pipe Should Be Washed To
Remove Any Extraneous Matter There May Be Such As Welding Pellets,
Cut-Offs From Gaskets, Etc.
6. Secure The Inlet Pipe To Keep It From Moving Or Bending If Using Soft Pipes.
(We Recommend Stiff Pipes Inside The Tank.)
7. Place The Machine In An Upright Position And On A Sturdy Resting Place.
8. When The Pump In/Outlet Are Lower Than The Liquid Level Of The Tank,
Install Valves On The In/Outlet Pipe To Prevent Siphoning.
9. Please Make Sure The In/Outlet Connection Flange Are Equal In Diameter
With In/Outlet Flange. Please Make Sure All The Bolts And Nuts Are
Adequately Tightened, Including The Wing Nuts On Top Cover.
10.
The Wire Connection Diagram Could Be Found In The Connection ox On
The Motor For Various Voltages.
11.
Use A Electromagnetic Switch. It Will Automatically Cut-Off The Power
Supply If The Motor Overloads. When Installing A Fuse Or A Motor
Protection Device,Choose The One Which Allows Current Higher Than
Rated.
(Please Refer To The Current Rating And Voltage On The Marking To Motor By 10 ~ 20 %.)
