10
Installation
Cautions
1. Place the machine horizoztal stably and keep it up-right.
2. Connect the inlet and outlet pipes according to picture 1. The inlet pipe is
connected to the AODD pump. The outlet pipe is connected to
the outlet under the filter plate.
3. A valve should be installed on the inlet pipe so repairing can be done
easily (picture 2).
4. Set a Tee at the inlet of feeding pump to supply clean water for cleaning.
5. There should be no foreign substances inside the pipe before pumping.
If necessary, clean it with water.
6. Make sure the installed pipes are steady. There should be no vibration.
7. Connect the air pressure pipe to the inlet of the 3-point joint.
8. The external air compressor must match the refrigerating dryer in
specification.
9. Refer to picture 3 for the pumping method of the air compressor and
refrigerating dryer.
10. This machine is 380V, 3-phase. Please connect the power line to the
upper part of the circuit breaker.
11. Please turn on the motor and check whether the direction of operation
is correct after the installation.
12.The refrigerating dryer is external single-phase, 220 V. Refer to picture
3 for power supply.
13. Air compressor power is supplied from ST-60N’s control panel. You
can connect the power line from the bottom part of the circuit breaker to
the air compressor power line housing.
14. Please turn on the power and check whether the operating direction
is correct after assembling the power line of the air compressor.
15. Please refer to the respective instruction manual if you don’t
understand the air compressor & refrigerating dryer fully.
