1. These instructions are best followed on a full ice bin with at
least 3 inches of ice resting against the brass thermal well.
The machine must be running to perform this adjustment;
follow step two if the machine is off.
2. Turn the thermostat adjustment screw clockwise until it
stops; this is the max cold setting and will prevent the
machine from shutting off.
3. Hold a minimum of 3 inches of ice against the middle of the
brass thermal well for 3-4 minutes. It is imperative that
enough ice be used for the
4. Slowly turn the adjustment screw counter- clockwise until the
machine shuts off. If the screw is turned too quickly, the
thermostat could be set to too warm a temperature. Turn
slowly.
5. Remove the ice from the well and warm the brass with your hand; the machine should turn
back on.
The ice machine is now set for ambient conditions. If the ice machine location experiences
significant changes in ambient temperatures, this procedure will need to be followed again.
Adjustments are not covered under warranty.
© Supera
September 2015
1
1
