Superabrasive
User Manual Original Language
Lavina® 30GEB
1/2021
17
WATER FLOW CONTROL SYSTEM
The water system is designed to supply water directly on the tools.
The water supply is coming either from the tank or from external
water source:
- water supply from the tank:
Put the internal water valve into position „ON” (along the axis
of the machine) Figure 4.2 and close the external valve Figure
4.3, so the water could flow from the tank through the
internal valve over the tools.
You can adjust the water flow by putting the internal valve in
an intermediate position.
- external water supply:
Put the internal water valve into position „OFF” Figure 4.1
and open
The external valve Figure 4.4, so the water could flow through
the external valve over the tools.
You can adjust the water flow by putting the external valve
in an intermediate position.
ALWAYS USE CLEAN WATER TO PROTECT THE SYSTEM FROM DIRT.
Figure 4.1
Figure 4.2
Figure 4.3
Figure 4.4
Figure 4.5
