Superabrasive
Owner’s Manual Original Language – Lavina
®
V32G-X/GTX
14/2019
15
Now place the two new HEPA filters in the box. Put back the cover and close the latches. Close the head cover
(pos.2;fig.5.3) and lock the 3 latches (pos.1;fig.5.3).
5.5 LONGOPAC® BAG REPLACEMENT (CHANGING BAGS)
V32GX has a Longopac system for effective dust storage.This is a
20 m long plastic tube that will be divided into plastic bags using the
zip ties attached to the machine.
IMPORTANT:
TURN OFF VACUUM:
1. CLOSE SERVICE VALVE ON PROPANE TANK
2. TURN THROTTLE TO THE IDLE POSITION
3. TURN OFF KEY SWITCH
The collected dust accumulates in the cyclone until the machine is
switched off, when it drops through the bottom flap into the plastic
bag.
• Make sure that there is approximately 6-8 inches of an empty bag
located between the bottom of the dust container and the top of the
debris/waste.
• Install 2 zip ties, or cable ties, around the plastic bag: 1 located
above the top of the debris/waste, and a 2nd tie located
approximately 3-4 inches higher up on the bag). Both ties must be
securely tightened in order to prevent the opening of the bag and
possible spillage (Fig 5.8).
• Using a sharp knife or scissors, cut across the entire section of
plastic bag located between the 2 zip ties, or cable ties (Fig 5.8).
Remove and dispose of the bag section containing the dust and
debris.
• Pull down on the bag until the end reaches the lower, bag-support
plate (Fig 5.9).
IMPORTANT: When disposing of bags containing debris, be sure to
use waste disposal containers and methods that fully comply with all
environmental laws and regulations that are applicable to your
specific country and location.
Figure 5.6
Figure 5.7
Figure 5.9
Figure 5.8
