Superabrasive
Owner’s Manual Original Language – Lavina
®
V32G-X/GTX
14/2019
20
6. MAINTENANCE AND INSPECTION
Tampering w/Emission Control System Prohibited
Federal law and California State law prohibits the following acts or the causing thereof: (1) the removal or rendering
inoperative by any person other than for purposes of maintenance, repair, or replacement, of any device or element at
design incorporated into any new engine for the purpose of emission control prior to its sale or delivery to the ultimate
purchaser or while it is in use, or (2) the use of the engine after such device or element of design has been removed or
rendered inoperative by any person.
Among those acts presumed to constitute tampering, involve the parts/systems listed below:
Carburetor and internal parts
Spark plugs
Magneto or electronic ignition system
Fuel filter element
Air cleaner elements
Crankcase
Cylinder heads
Breather chamber and internal parts
Intake pipe and tube
WARNING!
Before cleaning and servicing the machine, you must turn the machine off and disconnect battery and propane
tank
ATTENTION!
Wait until turbine impeller has completely stopped before starting servicing the machine.
The exhaust will get very hot after running the engine for just a short time
Before moving the dust collector from the working area, the machine must be cleaned.
All other equipment must be considered to be contaminated and be treated thereafter.
If possible, use a special suitable room.
Proper personnel protective equipment must be used.
After a service, all parts that are contaminated must be taken care of properly in plastic bags, according to
all regulations.
If the dust collector has to be used for other purposes, it is extremely important that the machine is
cleaned to avoid the spread of hazardous dust.
In order to ensure safe and efficient operation of the dust collector, the following procedures should be performed
periodically (depending on the frequency of operation):
Remove and inspect the filters for any signs of excessive wear or damage. Replace as necessary. (See
section on “Filter Removal”).
Ensure that the gaskets on the filters are free of excessive wear or damage. Replace as necessary.
Inspect all electrical components (switches, plugs, cables, etc.) for damage or exposed wiring. Replace as
necessary.
Ensure that all screws, bolts, and nuts are properly tightened.
Check the waste container level. Always clean and change the bag when the debris reaches a maximum of
75% of its full capacity.
Check the flexible vacuum hose and accessories for significant wear or damage. If holes are present, the dust
collector’s efficiency will be reduced, and debris will leak into the work environment. IMPORTANT: All major
repair work should be performed by Superabrasive or an authorized repair facility.
Check the turbine belt tension.
Check and clean the Propane installation.
CHECK DAILY
After operating the
V32GX
, the operator should conduct a visual inspection of the machine. Any defect should be
solved immediately. Pay attention to plugs and vacuum hoses, loose bolt or screws.
