Dimmable LED Panel Light
Important: Read all instructions prior to installation.
Rev Date: V1 11/16/2018
Recommended Accessories
Included Parts
Specifications
1 - LED panel Light
• 0–10V Slide Dimmer (F019)
• 0–10V Knob Dimmer (A019)
Model
LPD4-xK22-40-SM15N
LPD4-xK24-50-SM21N
Operating Voltage
120–277 VAC
Rated Power Consumption
40 W
50W
Current Draw
330mA @ 120 VAC
420mA @ 120 VAC
Beam Angle
110 degree
Dimmable
0–10 V
Operating Temperature
14–104°F (-10–40° C)
Product Weight
5 lb (2.3 kg)
10 lb (4.5 kg)
IP Rating
IP20
LPD4 Series
Drop Ceiling Installation
Safety Information
•
Product should be installed by a certified electrician in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source
and circuit breakers are switched off before performing any installation
or wiring procedures.
• Avoid looking directly into the light when illuminated.
•
Failure to properly support the fixture may result in damage or injury, for
which the manufacturer does not assume responsibility. A safety cable
is not included, but it is recommended that one be connected to grid clip
during installation.
Wiring Diagram
1.
Turn supply power to circuit off. If installing as a retrofit, remove existing fixture.
2. Open driver box and remove knockout(s) for wiring. Make electrical connections using
wiring diagram. Once complete, resecure driver box cover.
3. Bend out safety tab to be vertical, then upper portion out 90 degrees.
It is recommended that a safety cable (purchased separately) be installed
to anchor the fixture as well.
4.
Lay fixture into T-grid.
Note: Tabs should secure light in
T-grid while still allowing reinstallation
of adjacent ceiling tiles.
FIG 2
FIG 1
Safet Tab
Driver Box
Fixture
Driver Box
Cover
T-Grid
Firmly bend Safety Tabs
up and out
Safety Tab
User Manual
Black
L
L
N
N
GND
GND
White
Green
+
+
–
–
Purple
Gray
Black
White
Green
Purple
Gray
120–277 VAC
Supply
0–10 V Dimmer
