Page 11 of 16
Form 0135J 11/23/2004
Superchips Inc.
Superchips Inc.
1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
The MAX MicroTuner flash the following message:
Please Wait…
The MAX MicroTuner will then beep and display the message:
Turn Ignition ON
Do NOT START Eng
Or
Turn Ignition
On Press ‘>’
Turn the ignition to the ON position, DO NOT ATTEMPT TO START the vehicle. If
necessary, press the ‘>’ key to continue.
The MAX MicroTuner flashes the following message:
Please Wait…
Leave the ignition ON until instructed otherwise. The MAX MicroTuner will then display the
following message:
RETURN to STOCK?
YES or NO
If ‘NO’ is pressed, the
MAX MicroTuner will return to
Installing the Superchips
Performance Program
at Step 5 above.
If ‘YES’ is pressed, the MAX MicroTuner will repeat the following sequences for up
to three files, depending upon your vehicle configuration, where N is the number of
the file being programmed.
The MAX MicroTuner will display the message:
Program Engine
File N XX.X%
(00.0 – 100.0%)
Please Wait…
When 100% of the first file has been programmed, the MAX MicroTuner will beep and
display the message:
Turn Ignition
OFF Press ‘>’
Turn the ignition to the OFF position, then press the ‘>’ key. The MAX MicroTuner will flash
the following message:
Please Wait…
The MAX MicroTuner will then beep and display the message:
Turn Ignition ON
Do NOT START Eng
Or
Turn Ignition
On Press ‘>’
Turn the ignition to the ON position, DO NOT ATTEMPT TO START the vehicle. If
necessary, press the ‘>’ key to continue.
When 100% of the all the files have been programmed, the MAX MicroTuner will beep and
display the message:
Turn Ignition
OFF Press ‘>’
Page 12 of 16
Form 0135J 11/23/2004
Superchips Inc.
Superchips Inc.
1790 East Airport Blvd., Sanford, FL. 32773 (407) 585-7000 http://www.Superchips.com
Superchip & Superchips are registered trademarks of Superchips, Inc.
Turn the ignition to the OFF position, then press the ‘>’ key. The MAX MicroTuner will beep
and display the following message:
Please Wait…
Then
Turn Ignition ON
Do NOT START Eng
Then flash
Please Wait…
If a Tire Height change was installed, The MAX MicroTuner will blink the following
message:
Adjusting Speedo
Please Wait…
Once the speedometer programming is complete, the MAX MicroTuner will display:
Adjusting Speedo
Complete!
Please Wait…
When the programming sequence is completed the MAX MicroTuner beeps and will display:
Vehicle is at
Stock setting
Turn the
Ignition OFF
Remove the MAX
MicroTuner
Turn the ignition to the OFF position and unplug the MAX MicroTuner from the vehicle. It is
now safe to operate your vehicle in a normal operation.
