2WD Self Balancing Robot
SuperDroid Robots, Inc
Contact
224 Technology Park Lane
(919) 557-9162
Fuquay Varina, NC 27526
Revised: February 8, 2019
Page 3 of 6
Mechanical Assembly
1.
Start by mounting the motors to the chassis base. Use the provided M3 screws and make sure to use
threadlock to keep the screws from vibrating loose.
2.
Before you mount the upper decks, mount the motor controllers while you have better access.
3.
Assemble the wheels to the shafts using the provided hardware and threadlock. At this point you can mount
the shafts to the motors using the provided ¼-20 set screws. It may be helpful, however, to leave the wheels
off while you finish building and wiring the robot.
4.
Before mounting the middle deck, mount the switch, fuse block and the rest of the electronics. Drill a ½” hole
to mount the switch. Use the plastic spacers and hardware provided in the hardware kit to mount the fuse
block and other electronics.
5.
Mount the ¼-20 threaded rods to the chassis base using the nuts provided. The threaded rod should be
about flush with the end of the nut on the bottom of the chassis base. Secure the threaded rods to the chassis
base by tightening another nut on the top side of the chassis base. Secure the upper decks by again
