SuperDroid Robots IG32 DB Assembly And Operation Manual Download

Page: 5 / 6

Mecanum Wheel Vectoring Robot Platform

–

IG32 DB

SuperDroid Robots, Inc

Contact

224 Technology Park Lane

(919) 557-9162

Fuquay Varina, NC 27526

Revised: April 25, 2018

Page 5 of 6

Mark the holes for the motor controller and drill them out to 1/8”. Use the hardware in the provided

hardware kit to mount it.

Mark and drill a hole to mount

the fuse block (also 1/8”).

Electrical Assembly

For electrical assembly please follow the provided schematic on our website:

For additional support on wiring, soldering, and crimping, please read the following support pages:

Summary of Contents for IG32 DB

Page 1: ...eration This is a direct drive 4WD base robot kit that uses Nexus mecanum wheels and hubs It s a great robot platform for indoor robotics It can vector in any direction Images shown may not be an exact representation of the robot s features listed in this document ...

Page 2: ... SuperDroid Robots Inc Contact 224 Technology Park Lane 919 557 9162 Fuquay Varina NC 27526 SDR SDRobots com www SuperDroidRobots com Revised April 25 2018 Page 2 of 6 Contents Mechanical Assembly 3 Electrical Assembly 5 Operation 6 General Terms 6 ...

Page 3: ...s com Revised April 25 2018 Page 3 of 6 Mechanical Assembly 1 Start by mounting the motors to the chassis using the M3x8 screws Use Loctite to insure the screws do not vibrate loose 2 Slide the steel hub onto the motor shaft so that it is very close the chassis and the screw heads but not touching Tighten the set screw down onto the flat part of the motor shaft Use Loctite ...