5.
Use the test light provided in the kit, identify the power and ground wire to the
reverse light. Make sure the alligator clip on the test light is attached to a good
ground (For help in locating the vehicle’s reverse light circuit, contact your
vehicle’s manufacturer for vehicle specific wiring diagrams) If the test light
lights up, then the wire corresponding to that contact is the power wire. Connect
the red wire from the camera’s power cord to the power wire, and the black wire
to the ground wire.
Use the quick splices included in the package for wire connection Securely fasten
the wire to prevent it from being caught on any vehicle component such as the
trunk hinge. Never route the cable on the outside of the vehicle.
Insert the existing wire to be tapped Insert the wire to be attached Crimp tap with pliers then close lock
