Premier VS Infrared Heating System
Page 37
June 04, 2014
INSTALLATION –
Part 1
E
- Optional Shield Equipment
Bottom Shields
Bottom Shields do not need to overlap. Each 5 ft (1.5 m) section is held with two Support Brackets. Secure each
of the Support Brackets around the Tube with a #8 x 3/8” screw.
Refer to Figure 24 below for reference.
Burner Reflectors
Burner Reflectors are used to maintain a continuous Reflector surface along the length of the Heat Exchanger
instead of ending & restarting Reflector runs with End Cap s at each Burner location.
Burner Reflectors are installed after the Burner installation, and before / during assembly of the main Reflector
run. All pieces are connected using #8 x 3/8” Screws. The Side pieces and End Sections are installed first to
create a Base to secure the Burner Reflector sections to. Overlap the Burner Reflectors with Standard
Reflectors, secure the Reflectors together with Support Brackets. Refer to the sequence of images in Figure 25
for more detail.
Bottom Shield Bracket
Secure Bottom Shields to Brackets after
Brackets are installed on Tubes
It is easier to install Bottom Shield
assemblies before Reflectors are in-place.
Install Brackets, tighten screws
#8 x 3/8" Screws
Tube Section
CR017
Bottom Shield
CR018
Figure 24: Bottom Shield Installation Detail
