H07023380 / DT2000477-03
English
4.5 REMOTE CONTROL KIT (OPTIONAL)
DT2011677-01
DT2032445-0
B
A
Fig. 43
- Referring to the paragraph “
REMOVING THE CLADDING
”, remove the lower
front panel and the right side panel.
- Remove the connector of the DB9 port from the connexion [A] on the
electronic board. (Fig. 43)
- Connect the cable with receiver to the electronic board and the DB9 port, as
shown in the wiring diagram. (Fig. 44)
- Place the receiver that has just been installed in the front of the stove,
ensuring that the cable runs inside the stove and securing it with the clamps
[B] to be found in the base and which already hold the smoke extractor fan
cable. (Fig. 43)
- Fit the remote control receiver [C], in the direction as shown in the fi gure to
the side, onto the inner face of the removed front panel and fasten it to the
threaded bush using the screw provided in the kit. (Fig. 45)
- When installing align the spherical rounded part of the receiver [C] with the
central slot in the lower front panel [E].
- Check that the remote control receiver cable cannot come into contact with
parts of the stove that may become hot when the stove is in use.
- Refi t the previously removed cladding.
- Use the remote control functions as described in the section “
USE
”
DT2032447-0
A
C
Fig. 44
DT2032448-0
C
D
C
E
Fig. 45
Incorrect alignment can impair remote control reception.
If the remote control kit is installed, it’s not possible to install at
the same time the GPRS module and vice versa.
19
Summary of Contents for MONIA
Page 42: ...H07023380 DT2000477 03 42 ...
Page 43: ...H07023380 DT2000477 03 43 ...
