Superior
PAPER HANDLING SOLUTIONS
8
© 2005-2015 Superior-PHS
3.
Skip Flight:
When running on a lugged/flighted conveyor you can add a Skip Count to
miss desired lug pockets. When set to “0”/zero the system will feed or drop into every
pocket. When set to 1 the system will feed/drop into the first pocket, then skip one
pocket, then feed the next pocket and repeat sequence. If Skip Flight is set to 2, then
system will feed first pocket and skip the next 2, and etc. Press the value/number
button to bring up keypad. Enter required value, press enter to save and return to Main
Set-up Screen.
4.
Pause/Resume ON/OFF:
Pause/Resume can operate in feeder only or with the
dropper on. When Pause/Resume mode is turned ON, press the cycle button to start the
first batch, then Feeder will automatically
“Pause” at the end of the first batch for the
preset amount of Pause Time, then Automatically Resume the next batch. This creates
a gap on the shingling conveyor notifying the operator where the batches begin and end.
Press the ON/OFF button to toggle between ON and OFF. The pause time can be set
by using the pause/resume input ( #5 below ).
5.
Pause/Resume Time:
When Pause/Resume mode is turned ON, sets amount of
Pause time between end of a batch and the automatic starting of the next batch. Press
adjacent time button to bring up keypad. Enter required Pause time, press enter to save
and return to Main Set-up Screen.
6.
Up/Down Screen Arrow Buttons
: When pressed moves to the next screen.
7.
Run Screen Button
: Takes operator directly to Run Screen
8.
Dropper Screen Button:
Takes operator directly to Dropper screen.
