MAXIMUM PERFORMANCE.
SuperMaxTools.com
sales@SuperMaxTools.com
P. 888.454.3401
F. 651.454.3465
© 10/2017 SuperMax Tools
#71938-7F-CL
INFEED/OUTFEED TABLES
— FOR CLOSED STANDS —
1. Attach each table base bracket (#4) to the sander
using the two socket head caps crews (#16) and 3/8”
flat washers (#17).
3. Place a straightedge across the table and conveyor to
check for level. Raise or lower the table until level with
the conveyor and then tighten the carriage bolt nuts.
NOTE: Use the set screws (#19) to level the table.
2. Mount each table (#1) to the base bracket using four
carriage bolts (#9), 1/4” flat washers (#11) and hex
nuts (#10).
NOTE: Leave the bolts loose for now.
4. To lower the tables push the lock buttons on each side to
release the table lock and carefully lower the table.
NOTE: When raising the tables for use, make sure the lock button
clicks into place and test by applying downward pressure to the
tables to make sure it is secure before beginning sanding operations.
SAFETY FIRST
• Tighten all fasteners when installing. Before using your extension tables make sure they are properly secured to the sander fol-
lowing the instruction below and that all nuts, bolts, lock pins, and other fasteners are fully tightened.
• Make sure extension tables are locked in the up position when in use. Make sure the tables click and lock in the “up” position
before beginning sanding operations
• Use caution when folding the extension tables down for storage. Hold the table for support as you unlock it and slowly lower it in
the “down” position for storage. Do not allow the table to drop suddenly and keep hands and all body parts away from any potential
pinch points between the extension tables and the machine or its stand.
INSTALLATION INSTRUCTIONS
