16 S
UPER
B
RUSH
O
WNER
’
S
M
ANUAL
The basic adjustment procedures for your machine
are covered under Setting Up Your S
UPER
B
RUSH
,
page 6. Review that section first. If following the
general instructions does not solve a specific problem
or result in smooth operation, also check
Troubleshooting Your S
UPER
B
RUSH
, page 13.
Below are suggested procedures to follow when
more thorough readjustment or replacement is
necessary.
A
DJUSTING
H
EIGHT
C
ONTROLS
Height adjustment problems may be the result of
not loosening the set screws in the table support
castings before attempting operation. (This is
covered on page 5 of this manual, and also on the
separate unpacking sheet which was shipped with
your machine.) If the set screws were not loosened
as instructed, do so now before proceeding further.
Also make sure all moving parts of the height
adjusting mechanism are well lubricated, including
the miter gears, column tubes, and threaded
height adjusting screws.
When troubleshooting the height adjustment
mechanism, first check the conveyor table for level
(see page 7). Then test the height adjustment
mechanism (See Fig. 13). If it does not operate
easily, further adjustments may be necessary, as
outlined below. Following these steps should result
in smooth operation.
Readjustment Procedure
1. Loosen the set screws located at the front of the
table support castings (Fig. 3).
2. Lubricate thoroughly by applying penetrating
lubricant to the table support castings where they
contact the column tubes, and to all contact points
of adjusting screws and transfer rod (Fig. 15). Also
apply grease or oil to the miter gears.
3. If the height adjustment feels stiff, check for
misalignment of adjusting screw supports and the
brush support castings which could cause binding
on the adjusting screw (Fig. 5). These castings can
be adjusted by loosening the set screws which
secure them to the column tubes. Realign the
adjusting screw supports by loosening the two set
screws that hold them to the column tubes and
rotate to the proper position.
4. The adjusting screw supports located immediately
below the height adjustment handle and the left
S
ERVICING
Y
OUR
S
UPER
B
RUSH
Fig. 13. Table support casting set screws.
Fig. 14. Adjusting miter gears for proper mesh.
