7-2
S
UPER
S
ERVER 1027R-73DAF User's Manual
How To Change the Confi guration Data
The confi guration data that determines the system parameters may be changed by
entering the AMI BIOS Setup utility. This Setup utility can be accessed by pressing
<Delete> at the appropriate time during system boot.
Note
: For AMI UEFI BIOS Recovery, please refer to the UEFI BIOS Re-
covery User Guide posted @
http://www.supermicro.com/support/manuals
/.
Starting the Setup Utility
Normally, the only visible Power-On Self-Test (POST) routine is the memory test.
As the memory is being tested, press the <Delete> key to enter the main menu of
the AMI BIOS Setup utility. From the main menu, you can access the other setup
screens. An AMI BIOS identifi cation string is displayed at the left bottom corner of
the screen below the copyright message.
Warning!
Do not upgrade the BIOS unless your system has a BIOS-related is-
sue. Flashing the wrong BIOS can cause irreparable damage to the system. In
no event shall the manufacturer be liable for direct, indirect, special, incidental,
or consequential damage arising from a BIOS update. If you have to update the
BIOS, do not shut down or reset the system while the BIOS is being updated to
avoid possible boot failure.
7-2 Main Setup
When you fi rst enter the AMI BIOS Setup utility, you will enter the Main setup screen.
You can always return to the Main setup screen by selecting the Main
tab on the
top of the screen. The Main BIOS Setup screen is shown below.
Summary of Contents for 1027R-73DAF
