24
SuperStorage Server 6039P-E1CR16H/L User's Manual
Chapter 3
Component Installation and Maintenance
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and part
numbers given.
Remove power from the system before installing or replacing components. Refer to Section
3.1.
3.1 Removing Power
Use the following procedure to verify that power has been removed from the system. This
step is required when removing or installing non hot-swap components or when replacing a
non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has fully shut down, disconnect the AC power cord(s) from the power
strip or outlet. (If your system has more than one power supply, remove the AC power
cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Accessing the System
The 836BE1C-R1K23B features a removable top cover, which allows easy access to the
inside of the chassis.
Removing the Top Cover
1. If necessary, remove power from the system as described in Section 3.1.
2. Remove the two screws securing the cover to the side of the chassis.
3. Depress the release tabs on the top of the chassis.
4.
Slide the cover toward the rear of the chassis and lift the cover off.
Warning
: Except for short periods of time, do not operate the server without the cover in place.
The chassis cover must be in place to allow for proper airflow and to prevent overheating.
