Chapter 3: Server Installation
35
Power Distributor
The CSE-813MF2-R_RCB chassis comes equipped with a power distributor. In the unlikely
event that you need to replace the power distributor, use the following instructions.
Changing the Power Distributor
1. Power down the chassis as described in section 3.1. Unplug the power cords from the
rear of the power supplies. Remove the chassis from the rack and seat it on a work
bench (safety area). Then open the chassis cover as described in section 3.2.
2. Remove the power distributor cover.
3. Remove the four screws as the illustrated below.
4. Lift the power distributor up and out of the chassis.
5. Put a replacement power distributor of the same model into the power distributor bay.
6. Replace the screws, plug the power cords into the rear of the power supplies and power
up the system as described in section 3.1.
Figure 3-11. Removing the Power Distributor
4
