4-3
Chapter 4: Chassis Setup and Maintenance
4-3 Cable Connections
BMC LAN Connection
The Control Board offers intelligent management with the baseboard management
controller (BMC) providing hardware health monitoring and remote power control. To
enable, connect to the storage enclosure using the dedicated BMC LAN connector
(Figure 4-2).
For more information on the BMC, see Section 6-6 in this manual.
Removing Power from the System
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your system
has dual power supplies, remove the cords from both power supplies.
2. Disconnect the cord from the power strip or wall outlet..
