6-9
Chapter 6: Rack Installation
Figure 6-7: Chassis Installed in a Telco (Post-Style) Rack
6-5 Installing the Server into a Telco Rack
To install the chassis into a Telco (post) type rack, use two L-shaped brackets (Op-
tional with the MCP-290-00016-0N) on either side of the chassis (four total). First,
determine how far follow the chassis will extend out the front of the rack. Larger
chassis should be positioned to balance the weight between front and back. If a
bezel is included on your chassis, remove it. Then attach the two front brackets to
each side of the chassis, then the two rear brackets positioned with just enough
space to accommodate the width of the Telco rack. Finish by sliding the chassis
into the rack and tightening the brackets to the rack.
Summary of Contents for SC118G-R1400B
