SC513B Chassis User's Manual
6-8
Figure 6-5. Installing into an Open Rack
Installing the Chassis into a Mid-Mount Position (Telco) Rack
1.
Use the two L-shaped brackets (four total) to suspend the sides of the chassis within the
rack.
2.
Determine how far the chassis will extend out the front of the rack. Larger chassis
should be positioned to balance the weight between front and back. If a bezel is includ-
ed on your server, remove it.
3.
Attach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
4.
Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Note:
These figures are for illustrative purposes only. Always install servers into racks from
the bottom up. The chassis shown may differ from the one you have purchased.
